AirTap Heat Pump Water Heater

It is said that every person in the United States are using about 15 times more energy than other countries and thereby spending billions of dollars every year on energy costs according to the Department of Energy. There are so many products on the market that say they can reduce the cost of energy but often these products don’t make the cut.

There is a new water heater out there called the AirTap. This is a water heater that is not run by the standard gas, oil or even electric. The AirTap Heat Pump Water Heater is run simply by the air surrounding the water heater. Imagine how much lower your bills would be without using gas, oil or electric to get the hot water that you need.

The way this system works is that the AirTap is connected to your existing water heater, the device works just like a heat pump, which uses a compressor that is powered up by a very low wattage electrical requirement. The heat is then taken from the surrounding air and then the heat travels through long copper tubes through an adapter and then it is distributed into the water tank. The water gets as hot as it would just like a gas fired water heater. You lose nothing in the transfer by using this heat pump water heater. It is safe and very energy efficient. You will see the savings right away.

The AirTap will use much less power than it would take to power up a coffee pot. The amount of energy that this heat pump water heater uses is the equivalent to keeping at least 2 coffee machines for a total of 24 hours. There are many states in the United States that the Department of Energy offers rebates or tax credits. Some of the specifications of this AirTap unit is that the energy factor is 2.11. The unit is small; it measures in at 18 inches in width x 14 inches in diameter x 13 inches in height. The first hour rating of the AirTap is 43 gallons per hour.

The output on the AirTap is 7000 BTU’s. The maximum water temperature is 135 degrees, which is between 10 degrees between open and close. The electrical specifications on the AirTap is 110 volts, 12 amps start up with 6 operating. The unit is single phase with a 60 Hz. Some of the extra requirements on this unit is AirTap needs a 5 inch clearance on the top. The unit is an indoor installation but the water heater has to be installed near a drain. The reason is that the drain has to get rid of the condensate that is used while the air is processing more energy.

The AirTap is good in any weather condition, in the colder weather; the manufacturer suggests that the unit not be installed in a place where the ambient temperatures are below 35 degrees Fahrenheit. The efficiency of the device is used in colder weather; it will drop by 50%. The AirTap unit comes with a three year warranty when you purchase this device for your heat pump water heater. The first year is covered on all parts and labor, the second and the third year the warranty will replace parts for any part that is defective but the customer will provide shipping and handling and labor to repair it. There are two different AirTap Systems, the A7 and the AirVent; the Air Vent is the attachable device that goes onto the water heater for your existing water heater. This unit costs $699.00 and the Air Vent is a supplemental part that helps the AirTap work more efficiently. The AirVent is $ 79.00, you can buy this right from the AirGenerate website. If you are looking for a way to save money on your energy bills, then the AirTap is the way to go. Check out the website for more information.