Plumbing, Heating and Pool Repair Guides

What Motor Bearings Are In My Hayward Super Pump?

/
/
/
928 Views

The Hayward Super Pump motor has two bearings inside. If you super pump is starting to make a grinding or a screeching noise you may need to change your super pumps bearings. The bearings inside of the super pump can not be oiled or greased. If your pump is making those noises you will need to take the motor apart and replace the bearings. You will first need to remove the wet end or otherwise known as the pump housing from the electric motor.

Buy Motor Bearings for your Hayward Super Pump & More @ http://wetheadpumprepair.com

Once you have disconnected the electric motor from the pump housing you can then remove the motor through bolts. There will be four though bolts that will hold the motor end bells on to the motor armature. Once you have removed the electric motors armature you will see two ball bearings on each end of the motor shaft. The Hayward Super Pump uses two 6203 bearings.

Hayward Super Pump Motor

3 Comments

  1. rebuilding motor on Hayward super pump
    love the bearing videos…
    I pulled apart my motor,
    but I broke 3 out 4 bolts…the long bolts that run inside the motor
    Q. can I get 4 new bolts and cap from you…? how much will it cost?

  2. Hello there, simply became alert to your blog via Google, and located that it’s truly informative. I am going to watch out for brussels. I’ll appreciate when you proceed this in future. Numerous other folks can be benefited out of your writing. Cheers!|

  3. It’s in fact very complex in this full of activity
    life to listen news on TV, thus I only use web for that reason, and obtain the most up-to-date information.

Leave a Reply to mike Cancel reply

Your email address will not be published.

This div height required for enabling the sticky sidebar
Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views : Ad Clicks : Ad Views :