Bard has been in business since 1914, they started out in an office building in Ohio. The company was a small heating and plumbing contracting business and in the 90 plus years they have been in business they have grown to manufacturing geothermal heat pumps, wall mounted air conditioning units.
If you are looking for a new way to save money on heating and cooling bills, then you will want to try the Bard Geothermal Heat Pumps. These pumps offer quality, high performance and flexibility. Every pump is tested and is ISO-9001: 2000 Certified. Let’s take a look and see what the features and the specifications of the Bard Geothermal Heat Pumps have to offer. What makes Bard Geothermal Heat Pumps better than most? They offer high quality applications for both Ground Water and Earth Loops. Each geothermal heat pump comes with a scroll compressor and a Cupro Nickel Coaxial Water Coil. The Bard Geothermal Heat Pumps come with Slide In Electric Heater Packages.
These geothermal pumps have a domestic hot water heat exchanger that comes already factory installed. You will need an optional DPM26A Pump Module. These pumps come with a variable speed ECM Blower Motor. These geothermal pumps are available in GV Step Capacity Series Geothermal Heat Pump and the GSVS Series Geothermal Heat Pump Units. Each pump is shipped intact, complete with the internally wiring. You will have to complete the thermostat wiring, duct connections and the water piping.
Bard Geothermal Heat Pump Specifications
The Bard Geothermal Heat Pumps have three specified applications, the Ground Water, Ground Loop and Fresh Water Applications. The heating efficiency of these pumps ranges from 21,800 to 53,000 BTUH. All models have electrical options of 230/208 volts, single phase with 60 Hz. The cooling efficiency of these geothermal heat pumps is 14.5 to 22.0 EER and the Heating Efficiency ranges from 3.1 to 4.0 COP. These pumps do have electric heat options that range from 0 KW to 14 KW.
In the GV Step Capacity Series Geothermal Heat Pump comes in 5 different models. These geothermal heat pumps use the R-410A refrigerant and the GSVS Series Geothermal Heat Pump has 6 different models and they all use the R-22 refrigerant.
Each pump must be used with a filter, when you first purchase this pump it will come with a 2″ disposable filter. After a month or so you should check these filters and if they are dirty they should be replaced. When installing the condensate drain, you want to make sure that the installation is done in accordance with the local plumbing codes. The wiring should be done by a professional. To keep up with the warranty make sure that you hire a qualified technician to complete the installation.
Bard has been in business for over 90 years, they offer high quality and high performance geothermal pumps. These are commercial pumps and are not qualified for residential homes. All of the ratings on these pumps meet and exceed all of the requirements. These geothermal pumps have been found in schools all over the country. If your commercial building is in need of a new heating and cooling pump, try the Bard Geothermal Heat Pumps.