Comments on: Testimonials https://wetheadmedia.com/ Plumbing, Heating and Pool Repair Guides Fri, 23 Sep 2016 18:06:16 +0000 hourly 1 https://wordpress.org/?v=6.0.11 By: instagram terms https://wetheadmedia.com/testimonials/comment-page-1/#comment-23852 Fri, 23 Sep 2016 18:06:16 +0000 https://wetheadmedia.com/#comment-23852 Now I am going away to do my breakfast, after having my breakfast coming yet again to read further news.

]]> By: Plumber Helper https://wetheadmedia.com/testimonials/comment-page-1/#comment-23783 Thu, 21 Jul 2016 05:24:38 +0000 https://wetheadmedia.com/#comment-23783 In reply to BTR notary open on weekends.

Anytime, its a good read for anyone with a pump.

]]> By: BTR notary open on weekends https://wetheadmedia.com/testimonials/comment-page-1/#comment-23518 Tue, 12 Apr 2016 17:52:55 +0000 https://wetheadmedia.com/#comment-23518 Pretty! This was a really wonderful article. Thank you for supplying these details.|

]]> By: terry haynes https://wetheadmedia.com/testimonials/comment-page-1/#comment-22392 Sat, 15 Feb 2014 03:15:11 +0000 https://wetheadmedia.com/#comment-22392 bearings went out in the waterfall elect motor, disconnected the 240 volt wires to the motor, we had home warranty pool co come out and check out the motor, they turned in the job as complete, but left the wires disconnected,we call the home warranty co. and they said the job was complete, so i hooked the 240 volt motor up, when i turned the controls on, the circuit board started smoking,the bearings had not been replaced, and the motor was froze up. i replaced the motor and replaced the circuit board ( jandy 3652 circuit board ) the motor still does not work. i checked the voltage coming out of the 3652 circuit board 0 volts phase to phase, 120 volt phase to ground on both hot legs, it should have been 240 volts, the old motor i replaced was wired for 240 on the back, the control box has a 24 volt relay that clicks when you turn the waterfall pump on,

]]>