Comments on: Hayward Chlorinator Troubleshooting & Repair Guide

By: Jim Stutzman

Jim Stutzman — Sat, 13 Jul 2024 15:56:07 +0000

In reply to Cindy B. I am hacing the same probleml. I am trying replacement of the control valve (knob and stem w/ o-rings) Has anyone suggested a solution?

By: betuadollar

betuadollar — Mon, 09 Aug 2021 19:39:52 +0000

These chlorinators are just shit. They’ll be fine for two or three years and then the lid will refuse to tighten. Happens every time and no amount of lube or replacing the O ring will remedy that. Either will trying to clean up the threads or anything else.

By: Jerry

Jerry — Tue, 04 Aug 2020 19:55:26 +0000

In reply to Ann Auspaker. If you are talking about that plastic screw in the top of the lid you might have to use aa ratchet to get it undone I was told today that all it needs is snug tight with finger tips then many a quarter turn after that I broke mine when I tightened it too much.

By: Jerry

Jerry — Tue, 04 Aug 2020 19:48:02 +0000

In reply to Tony. I have the same problem I installed a new O ring greased it with the proper lube but when I put the lid back on I have to reaf it down extreamly tight. It works but I am not happy with how much I have to tighten it.

By: Brenda Schoenherr

Brenda Schoenherr — Sun, 28 Jun 2020 14:33:31 +0000

My tablets are not dissolving, it appears that the Chlorinator is blocked, how can I get this running again?

By: Scott Guymon

Scott Guymon — Sun, 03 May 2020 18:12:19 +0000

I have a salt water in ground. My box is saying that me chlorinate flow switch is off. How do I fix that?

By: Ann Auspaker

Ann Auspaker — Wed, 31 Jul 2019 17:46:45 +0000

Trying to install new O ring but can’t unscrew plug

By: Donna

Donna — Sat, 01 Jun 2019 11:54:53 +0000

I have the Hayward off_line chlorinator, it keeps leaking where the hose goes in.I replaced the white piece but if you tighten it too much the part that goes into the chlorinator breaks. This keeps happening. Don’t know what to do except get rid of it.

By: DAN PRATT

DAN PRATT — Tue, 10 Jul 2018 16:54:24 +0000

My advice is to get rid of it. Use the old fashion floater to chlorinate your pool. No noise, easy to fill and works just fine. Good luck.

By: TraceeJuicy

TraceeJuicy — Fri, 06 Jul 2018 06:31:19 +0000

I often visit your page and have noticed that you don’t update it often. More frequent updates will give your blog higher
rank & authority in google. I know that writing content takes a
lot of time, but you can always help yourself with miftolo’s
tools which will shorten the time of creating an article to a few seconds.